| Last Modified: 11-29-2007 | 1.6 A | |
| Service Category: Vehicle Exterior | Section: Door/Hatch | |
| Model Year: 2008 | Model: Sequoia | Doc ID: RM0000033Q5006X |
| Title: DOOR / HATCH: POWER BACK DOOR CONTROL SWITCH (for Luggage Compartment): REMOVAL (2008 Sequoia) | ||
REMOVAL
1. REMOVE NO. 2 DECK BOARD SUB-ASSEMBLY
2. REMOVE LUGGAGE COMPARTMENT TRIM BOX
3. REMOVE ROPE HOOK ASSEMBLY
4. REMOVE NO. 1 DECK BOARD SUB-ASSEMBLY
5. REMOVE DECK BOARD REINFORCEMENT SUB-ASSEMBLY
6. REMOVE DECK BOARD BRACKET
7. REMOVE REAR NO. 2 SEAT ASSEMBLY LH (for Manual Seat)
(a) Remove the rear No. 2 seat assembly LH
.
8. REMOVE REAR NO. 2 SEAT ASSEMBLY LH (for Power Seat)
(a) Remove the rear No. 2 seat assembly LH
.
9. REMOVE REAR SEAT CUSHION HINGE LOWER COVER LH
10. REMOVE REAR FLOOR STEP NO. 1 COVER
11. REMOVE REAR FLOOR STEP NO. 2 COVER
12. REMOVE REAR DOOR SCUFF PLATE LH
13. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH
14. REMOVE ROPE HOOK ASSEMBLY
15. REMOVE REAR FLOOR MAT SUPPORT PLATE
16. REMOVE QUARTER TRIM PANEL ASSEMBLY LH
17. REMOVE QUARTER TRIM PANEL ASSEMBLY LH (for Power Seat)
18. REMOVE REAR WINDOW NO. 2 SIDE GARNISH ASSEMBLY LH
19. REMOVE BACK DOOR CONTROL SWITCH
(a) Remove the screw.
|
(b) Using a screwdriver with its tip wrapped in protective tape, engage the claw and remove the No. 3 side trim base with back door control switch from the rear window side garnish assembly LH. |
|
(c) Using a screwdriver with its tip wrapped in protective tape, engage the 4 claws and remove the back door control switch from the No. 3 side trim base. |
|
|